Makita DMR056 Manual De Instrucciones página 8

Recommended cord
connected power source
Model Portable power pack
DMR056 PDC01
MR009G PDC01 / PDC1200
● The cord connected battery pack (s) listed above
may not be available depending on your region of
residence.
● Before using the cord connected battery pack, read
instruction and cautionary markings on them.
INSTALLATION AND POWER
SUPPLY
CAUTION:
● Always switch off the radio before installing or
removing the battery cartridge.
● Be careful not to drop or strike the radio. Broken shell
may slash your finger or stab your body. Damaged
radio may exhibit unpredictable behaviour resulting in
fire, explosion or risk of injury.
● Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
IMPORTANT:
● Reduced power, distortion, stuttering sound or screen
backlight flashing are all the signs that the battery
needs to be replaced.
● The battery cartridge is not included as standard
accessories.
Installing or removing the sliding
battery cartridge (Fig. 2-3)
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the radio, causing injury to you
or someone around you.
● Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, slide it from the radio
while sliding the button on the front of the cartridge.
Indicating the remaining battery
capacity (Fig. 4-5)
1. Indicator lamps
Press the check button on the battery cartridge to
2. Check button
8 ENGLISH
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
● XGT/LXT battery cartridge
Indicator lamps
Lighted Off
NOTE:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
● The first (far left) indicator lamp will brink when the
battery protection system works.
Charging with USB power supply port
NOTE:
● Connect only devices which are compatible with DC
5V, 2.4A power source to the USB power supply port.
Otherwise it may cause malfunction to the product.
● Connect the USB cable (not included) with the USB
power supply port of the product. And then connect
the other end of the cable with the device.
● To start charging, press the USB charging on/off
button to enable the charging function. The USB
charging on/off button will light up green.
● When the battery power is low, the screen backlight
will flash until the charging function is turned off.
● If the charging function is turned on without charging,
the USB charging on/off button will flash green, and
the charging function will be automatically turned off
after 30 minutes.
● To stop charging, press the USB charging on/off
button to disable the charging function.
● The maximum volume of the output power speaker
will decrease when your USB is charging.
IMPORTANT:
● Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
Remaining
capacity
Blinking
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the battery
The battery
may have
malfunctioned