Monster FlatScreen Manual Del Usuario página 14

Installing the FlatScreen Mount
Masonry Mounting
Masonry mounting requires specialized knowledge, skills
and tools. Monster highly recommends that you seek the
help of a professional installer when mounting to masonry.
1)
With the help of a friend, position the mounting plate
in your desired mounting location.
LEVEL
2)
Using the provided level, confirm that the
CHECK
wall plate is vertically straight. Position the level
horizontally with the narrow end flush against the side
of the wall plate. Hold the plate firmly in place.
3)
Mark the centers of the top and bottom mounting
holes on the wall plate with a pencil. Be careful not to
mark a mortar joint. With your electrical drill and 1/2"
masonry bit, pre-drill a 3" deep hole at each mark.
4)
Install the supplied plastic anchors in each hole.
Tap into hole until fully seated.
5)
Attach the wall plate to the wall using the supplied
lag bolts and round washers, as shown to the right.
6)
Attach the wall plate's Quick-Snap Screw Caps
to conceal the installed lag bolts.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
DO NOT release the wall plate until you
are absolutely sure it is secured to the wall.
10
All manuals and user guides at all-guides.com
continued