Tools Required; For Your Safety - Danby Silhouette Professional DIM32D1BSSPR Instrucciones De Uso

INSTALLATION SPECIFICATIONS - BUILT-IN

TOOLS REQUIRED

FOR YOUR SAFETY:

During installation gloves, safety glasses or goggles should be worn.
• It is recommended that you do not install the unit directly adjacent to a wall. This is to allow the door to have a
greater than 90° opening swing. A limited door swing can cause damage to the door gasket and you will not be
able to remove the bucket.
• The cabinet opening must be at least 25" deep by 15" wide. The opening should also have a height of at least 35".
• The electrical outlet may be positioned in either side of the adjacent cabinetry, or the rear of the shaded area
shown below. Plug in the unit before pushing it into position within the cabinet.
• If the electrical outlet is located inside the adjacent cabinetry, cut a 1-1/2" diameter hole to allow the power cord to
pass through it. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.
* If electrical outlet is in
35" from
underside of
countertop to
fl oor.
c
INSTALLATION INSTRUCTIONS
Adjustable
Wrench
Safety Glasses
Drill & Hole Saw Set
1-1/2" diam. hole
adjacent cabinetry.
25"
Min
2"
6"
15"
Flat Blade
Screwdriver
Level
Gloves Flash Light
Carpenters
Square
Measuring
Tape
NOTE: This unit is front breathing. Do not
block the front air vent. Blockage of the vent
will result in high operating temperatures and
system failure.
Cabinets
square and
plumb
2
Phillips
Phillips
Screwdriver
Screwdriver