English
During work
–
When working, always hold the power tool
with both hands on the handles [1-4]. This
is a prerequisite for precise work and is es
sential for plunge-cutting. Plunge into the
workpiece slowly and evenly.
–
Only guide the power tool towards the
workpiece when it is switched on.
–
Always push the saw forwards [8-1], and
never towards yourself.
–
Adapt the infeed speed to prevent the cut
ters on the saw blade from overheating and
prevent plastic materials from melting dur
ing cutting. The harder the material to be
sawn, the lower the feed speed needs to be.
–
Do not work with the machine if the elec
tronics are defective, because this may lead
to excessive speeds. You can tell if the
electronics are defective if there is no
smooth start-up or if it is not possible to
regulate the speed.
–
Make sure that the guard completely sur
rounds the saw blade before placing the
saw on the worktop or on the ground.
9.1
Sawing along the scribe mark
The gauge marker [7-1] displays the cutting
line for 0° and 45° cuts (without a guide rail).
7-1
9.2
Cutting sections
Position the machine with the front part of the
saw table on the workpiece, switch on the ma
chine, push it down to the set cutting depth and
push it forward in the cutting direction.
16
9.3
Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must always be followed
when plunge cutting:
–
Always position the machine with the rear
edge of the saw table against a fixed stop.
–
When working with the guide rail, position
the machine at the FS-RSP kickback stop
(accessory) [8-2], which is clamped to the
guide rail.
Procedure
► Place the machine on the workpiece and
position it at a stop (kickback stop).
► Switch on the machine.
► Slowly push the machine down to the set
cutting depth and push it forward in the cut
ting direction.
The marks [9-1] indicate the absolute front and
rear cutting points of the saw blade (Ø 6‑1/4"
(160 mm)) when using the saw at maximum
cutting depth with the guide rail.
8-1
7
8-2
8