SPIT AC1600 Manual página 13

G
Operating instructions
AC_1600_binnen.indd 13
All manuals and user guides at all-guides.com
Removing the filters:
• Switch off the vacuum cleaner by moving the switch (2a) to ''0''.
• Disconnect the electric cable (6) of the vacuum cleaner and
possibly the electrical tool cable from the socket (2b).
• Use a coin or a similar object to turn the locking system (5),
located on the latch (4), 90° anti-clockwise. Press the locking
system at the same time.
• Open the cover and remove each of the filters (12) towards the top.
• After cleaning, put back the two filters and check that they are
properly installed.
• Remove any dirt and close the cover. Press the cover slightly and
return the latch (4) to its initial position.
• Check that the cover is properly closed.
Your vacuum cleaner is again ready for use.
Changing the filters:
If the suction capacity decreases and cleaning the filters (12) does not
increase suction either (provided the container (7) has been emptied),
you need to change the filters (12). Proceed as described above to
remove the filters and install two new filters.
Both filters must be changed at the same time!
Other cleaning operations:
Clean the container and the accessories regularly with water. Leave them
to dry to prevent dust from remaining stuck on the damp parts.
Clean the engine protection filter (13) regularly.
Wipe the upper part with a damp cloth.
REFER ANY OTHER OPERATION TO SPIT
13
30-09-2005 14:22:03