Blumfeldt Heatbell Smart Wall Manual página 15

• Do not replace or attempt to replace the element in this product.
• Do not use this heater in the immediate surroundings of a bath, shower or
swimming pool.
• This product must not be left outdoors exposed to the elements for long
periods of time.
• Do not touch the plug with wet or damp hands.
• Do not run the power cable under carpeting. Do not cover the power cable
with rugs, runner, or similar coverings. Arrange the power cable away from
foot traffic and where it will not be tripped over.
• Do not wind the power cable around the unit.
• Do not insert or allow foreign objects to enter any ventilation or opening
on the heater, as this may result in electric shock, fire, or damage to the
heater.
• To prevent a possible fire, do not block the air vents.
• A heater has hot and arcing or sparking parts inside. Do not use in areas
where petrol, paint, explosive and/or flammable liquids are used or stored.
Keep unit away from heated surfaces and open flames.
• Where possible, avoid the use of an extension cable as this may overheat
and cause a fire. However, if you have to use an extension cable, ensure it
is suitable for the purpose, has been tested for outdoor use and preferably
has an RCD device fitted or attached.
• Always ensure the heater is plugged into a suitable socket, one that is
tested for outdoor use.
• Always unplug the unit and ensure the unit is completely cold before
moving, cleaning or storing.
• This heater is intended for domestic use only and should not be
used commercially for contract purposes. Any alternative use, not
recommended by the manufacturer, may result in fire, electric shock, or
injury to persons.
• The use of attachments on the heater is not recommended.
• Do not use this heater with a programmer, timer, separate remote control
system or any other device that switches the heater on automatically,
since a fire risk exists if the heater is covered or positioned incorrectly.
Important note on transport safety
Transport safeguards made of foam are located between the grids of the
heater. Completely remove the transport safeguards before operating the
device, otherwise there will be a risk of fire.
EN
15