Assembling; Wall Mounting; Adjusting The Heater Head - Blumfeldt Heatbell Smart Wall Manual

EN
16

ASSEMBLING

• When unpacking the heater, check that the scope of delivery is complete
and ensure that no device components remain in the packaging and that it
is free of packaging materials.
• Do not insert the power plug of the device into the socket until the device
has been completely assembled.
• Do not connect the heater to the power supply under any circumstances if
the components or the power cord are damaged.
• In case of doubt, contact the manufacturer, customer service or a similarly
qualified person.

WALL MOUNTING

• Attach the wall bracket to the heater using 2 M10x12 screws.
• Drill 4 holes with a diameter of 12 mm each into the wall.
• Press 4 screws into the drilled holes.
• Hold the heater and attach the wall bracket to the screws.
• Tighten the screws.
• After installation, insert the power plug of the unit into a grounded 240 V/
50 Hz outlet. The unit can now be used.
Note: During use, the heater must be facing down.
After fixing to a wall or ceiling direction of radiation cannot be changed
without the aid of a tool.

ADJUSTING THE HEATER HEAD

The heater head can be moved up or down once the mounting handle is
loosened.
Note: Do not attempt to adjust the heater head if the mounting handle has
not been loosened. Otherwise, the heater may be damaged.