Cub Cadet HT59L Manual Del Operador página 2

SAFETY INFORMATION
• Always stop the motor when operation is delayed, before setting down the unit or when walking from one
location to another. Make sure the blade comes to a complete stop.
• To avoid accidental starting, never carry the unit with fingers on the switch trigger.
• Always carry the unit by the front handle with the battery removed, finger off the switch trigger and the trimmer
blade sheathed in the scabbard and positioned to the rear
• Always make sure the switch lock is in the locked or OFF position before installing or removing the battery.
• Use extreme caution when cutting small-sized brush, as slender material may catch the trimmer blade
and be whipped toward the operator or pull the operator off balance.
• This unit is intended for infrequent use by homeowners. It is not intended for prolonged use.
MAINTENANCE AND STORAGE SAFETY
• DO NOT perform maintenance procedures other than those described in this manual. Do not
attempt to repair; there are no user serviceable parts inside.
• Follow all maintenance instructions in this manual.
• Before inspecting, servicing, cleaning, storing, transporting or replacing any parts on the unit:
1. Make sure all moving parts have stopped.
2. Allow the unit to cool.
3. Make sure the switch lock is in the locked or OFF position.
4. Remove the battery.
• Never remove, modify or make inoperative any safety device furnished with the unit.
• For safer, more effective performance, make sure the trimmer blade is sharp, properly cleaned and free
from obstructions.
• Frequently inspect the unit for damage. Before further use, any damaged part should be carefully checked
to determine that it will operate properly and perform its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts and any other conditions that may affect its operation.
Damaged parts should be properly repaired or replaced.
• Use only original manufacturer replacement parts and accessories, which are designed specifically to
enhance the performance and maximize the safe operation of the product. Failure to do so may cause
poor performance and possible injury.
• Remove the battery from the unit when not in use.
• Be sure to secure the unit while transporting.
• Always use the scabbard on the trimmer blade during transportation and storage.
• When not in use, store the unit in a locked-up and dry, or high and dry, place to prevent unauthorized use
or damage. Keep out of the reach of children.
• Keep the handles dry, clean and free from debris, oil and grease. Clean the unit after each use. Never
douse or squirt the unit with water or any other liquid. Do not use solvents or strong detergents.
• If dropped in water, do not use the unit.
• SAFETY AND INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that
may appear on this product. Read the operator's manual for complete safety, assembly,
operating, maintenance and repair information.
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be used in conjunction with other
symbols or pictographs.
• READ OPERATOR'S MANUAL
WARNING:
and safety instructions. Failure to do so can result in serious injury to the operator
and/or bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING:
injury and hearing loss. Wear eye protection meeting ANSI Z87.1-1989
standards and ear protection when operating this unit. Use a full face shield
when needed.
• KEEP BYSTANDERS AWAY
WARNING:
least 50 feet (15 m) from the operating area. If anyone enters the work area, stop
the unit!
• WEAR SAFETY GLOVES
Wear non-slip, heavy-duty protective gloves when handling the unit.
• WEAR SAFETY FOOTWEAR
Wear non-slip safety footwear when using this equipment.
• SHARP BLADE
WARNING:
injury, do not touch the blade. Keep both hands away from the blade while
operating the unit.
• DO NOT USE IN THE RAIN
WARNING:
unit in the rain or in damp or wet conditions. Moisture is a shock hazard.
SAVE THESE INSTRUCTIONS
2
Read the operator's manual(s) and follow all warnings
Thrown objects and loud noise can cause severe eye
Keep all bystanders, especially children and pets, at
The blade on this unit is sharp. To prevent serious
Avoid dangerous environments. Never operate your
KNOW YOUR UNIT
APPLICATIONS
This unit may be used for the purposes listed below:
• Trimming and forming hedges, shrubs and bushes with a
branch diameter of up to 1/2 of an inch (12.7 mm).
NO TOOLS REQUIRED!
Blade Support Rod
Upper Cutting Blade
Lower Blade
Scabbard
ASSEMBLY INSTRUCTIONS
This unit comes completely assembled.
UNPACKING
• Carefully remove the product and any accessories from the box.
• Inspect the product carefully to make sure no breakage or damage occurred during shipping.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
• If any parts are damaged or missing, please call 1-877-282-8684 (U.S.) or 1-800-668-1238 (Canada) for assistance.
INSTALLING AND REMOVING THE BATTERY
Follow these instructions in order to avoid injury and to reduce the risk of electric
shock or fire:
• Verify that the switch lock is in the locked or OFF position before installing or
removing the battery. Refer to Starting and Stopping Instructions.
• Verify that the battery is removed and the switch lock is in the locked or OFF
position before inspecting, adjusting or performing maintenance on any part of
the unit.
Installing the Battery
1. Align the tongue of the battery with the handle cavity (Fig. 1).
2. Grasp the rear handle firmly.
3. Push the battery into the handle cavity until the latch locks into place.
4. Do not use force when inserting the battery. It should slide into position and "click."
Removing the Battery
1. Press the latch button on the battery down and hold (Fig. 1).
2. Grasp the rear handle firmly and pull the battery out of the handle cavity.
NOTE: The battery fits into the handle cavity snugly in order to prevent accidental dislodging. It may require a strong pull to remove it.
CAUTION:
When the battery is not installed in the unit, keep it away from paper clips, coins, keys, nails, screws or
other metal objects that could make a connection from one terminal to another. Shorting the battery terminals together
may cause sparks, burns or a fire.
IMPORTANT! The battery is equipped with an internal circuit breaker that will automatically shut off power to the unit if the battery is
overloaded during heavy use. Once cooled, the battery will reset itself. Follow these steps if an overload occurs:
1. Release the switch trigger and then restart the unit. Refer to Starting and Stopping Instructions.
2. The battery may need to be removed for approximately 1 minute, allowed to cool and then reinstalled.
INSTALLING AND REMOVING THE SCABBARD
Installing the Scabbard
1. Grasp the rear handle firmly.
2. Slide the scabbard over the trimmer blade until it locks into place.
Removing the Scabbard
1. Grasp the rear handle firmly.
2. Squeeze both sides of the scabbard near the tip (Fig. 2) and slide the
scabbard off of the trimmer blade.
STARTING AND STOPPING INSTRUCTIONS
STARTING THE MOTOR
To help prevent accidental start-ups, this unit has a switch lock and switch
trigger that must be used together to start the unit.
1. Fit the battery into the handle cavity (Fig. 1). Refer to Installing the Battery.
2. Press and hold the switch lock (Fig. 3). This makes the switch trigger
operational.
3. While holding the switch lock, press and hold the switch trigger.
4. Release the switch lock and continue to squeeze the switch trigger for
continued operation.
STOPPING THE MOTOR
1. Release the switch trigger.
NOTE: It is normal for the trimmer blade to coast to a stop once the switch
trigger is released.
NOTE: Upon release of the switch trigger, the switch lock will automatically
reset to the locked position.
Front
Front Hand
Switch
Handle
Guard
Lock
Rear
Handle
Switch
Trigger
Battery
(Sold Separately)
Tongue
Latch
Button
Handle Cavity
Fig. 1
Squeeze Both Sides
to Release the Scabbard
Scabbard
Fig. 2
Switch
Lock
Switch
Trigger
Fig. 3