Descargar Imprimir esta página

Inserting The Battery; Removing The Battery; Setting The Power Level - Hilti TE 60-22 Manual De Instrucciones Original

Ocultar thumbs Ver también para TE 60-22:

Publicidad

Idiomas disponibles

Idiomas disponibles

5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4
Fitting the side handle
CAUTION
Risk of injury Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove in the product.
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the product.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.5
Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Release the side handle by turning the knob until the clamping band is slack.
3. Slide the depth gauge from the front into the 2 guide holes provided.
4. Secure the side handle by turning the knob until the clamping band is tight.
5. Tighten the side handle clamping band by turning the handle grip.
5.6

Setting the power level

After the battery is inserted, the product is always set by default to full power.
1. Press the "button for half power". The product runs at half power.
▶ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
▶ The "half power indicator" goes out.
5.7
Inserting / removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
*2267487*
3
4
5
2267487
English
9

Publicidad

loading