Water Supply - Kärcher K 2.800 eco!ogic Manual Del Usuario


Illustration
1 Connect high pressure hose to trigger gun.
2 Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.

Illustration
Connect the high pressure hose to the high
pressure connection of the appliance.

Water supply

Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Caution
Always connect the system separator to the wa-
ter supply, never directly to the appliance!
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.

Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).

Illustration
Screw the coupling element to the water
connection on the appliance.

Push the water supply hose onto the cou-
pling unit.

Connect the water supply hose to the water
supply.

Completely open the water tap.
Drawing in water from open reservoirs
Note: The max. suction height is 0.5 m.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.

Fill the suction hose with water.

Illustration
Screw the suction hose into the water con-
nection of the appliance and insert it into the
water source (e.g. rainwater drum).
14
Caution
Dry runs lasting longer than two minutes lead to
damages to the high pressure pump. If the appli-
ance does not build up pressure within two min-
utes, switch it off and proceed as instructed in
the Chapter "Troubleshooting".

Insert the mains plug into the socket.

Set the appliance switch to "1/ON".

Use the hand spray gun without spray lance.

Unlock the lever on the trigger gun.

Pull on the lever of the trigger gun; the device
will switch on.
Switch the appliance on for a (max. of 2 min-
utes) and wait until the water exits at the
hand spray gun without bubbles.

Release the lever on the trigger gun.

Set the appliance switch to "0/OFF".
Caution
Prior to cleaning, make sure that the high pres-
sure is placed safely on level ground. Wear pro-
tective goggles and protective clothing during the
cleaning process.

Illustration
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.

Turn on the appliance "I/ON".
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.

Illustration
Unlock the lever on the trigger gun.

Release the lever of the hand spray gun; the
appliance will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with high pressure nozzle
For normal cleaning tasks.
Not suitable for use with detergents.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
– 7
EN
Start up
Operation