Important - Labelmate LD-300-UNI Manual Del Usuario

STEP 1: INSTALL THE TENSION ARM
• The Tension Arm MUST be mounted on the same side as the sensor(BLUE, FIG.1 /3) is mounted.
• Loosen the Set Screw at the end of the Tension Arm (FIG.2) and position the Arm with the Set Screw facing the flat on
the Tension/Control Arm Shaft.
• Tighten the Set Screw facing the flat on the Shaft
• Re-insert and tighten the Tension Arm Shaft Screw (FIG.2) into the Tension Arm Shaft.
STEP 2: LOADING THE LABEL-ROLL
• Open the bracket that is supporting the Quick-chuck to carry the heavy label-roll (FIG.1/1)
• Place the label roll onto the quick-chuck and fix it by turning the black knob clockwise (CW).
• Close again the bracket that is supporting the Quick-Chuck (FIG.1/1)
• Feed the labels now under the tension arm (FIG.1/3) and over the first metal roller (FIG.1/4)
• Remove the first labels to have only the backing paper to attach to the web take-up shaft. Pull the label web under the
1st web guide.
• Thread the label web between the Stripper Bar and the round Guide Rod directly above it.
• Pull the label web under (or over) the second Web Guide and slide the edge guides to the width of the web.
• Pull the paper web above the take-up shaft. Remove the bail and push paper in the bail slot, place the bail back on the
paper to secure it. The prongs of the bail must face the paper in the gap between the vane and the shaft. Turn the bail
CW to secure it. To remove the paper, turn the bail CCW and remove it.
• Plug the Power Supply in a suitable power outlet and connect the LD-300-UNI who is now ready for use
• IMPORTANT: before pushing the START-button, the correct direction must be activated as demonstrated in FIG.3 !
• Now push the start button to bring the Tension Arm to its balancing neutral point
• Slightly loosen the Label Sensor Lock Knob, FIG.1/7 until you can just rotate the Sensor. Point the sensor up so it is
pointing at the bottom of the Stripper Bar.
• Slowly rotate the Sensor down until the label begins to advance. Continue to rotate the Sensor slowly until the desired
label length is protruding. Retighten the Lock Knob securely.
• IMPORTANT – Pull labels UP when removing them. If excess dust or dirt accumulates on the Label Sensor Eye the
Dispenser may not sense labels correctly. Use a cloth or paper towel dampened with water to gently clean the Label
Sensor.
• Do not use any chemicals on the sensor.
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions