Becken BKGH4446 Manual De Instrucciones página 21

• Ensure that the gas pipe and electrical cable are installed in such a
way that they do not touch any parts of the appliance which may
become hot.
• Gas pipe or connector shouldn't be bent or blocked by any other
appliances.
• Check the dimensions of the appliance as well as the dimensions of
the gap to be cut in the kitchen unit.
• The panels located above the work surface, directly next to the
appliance, must be made of non-flammable material. Both the
strati-fied surfacing and the glue used to secure it should be heat
resistant, to prevent deterioration.
• Turn on appliance tap and light each burners. Check for a clear
blue flame without yellow tipping. If the burners show any
abnormalities check the following:
- Burner lid on correctly
- Flame spreader positioned correctly
- Burner vertically aligned with injector nipple
• A full operational test and a test for possible leakages must be
carried out by the fitter after installation.
• The flexible hose shall be fitted in such a way that it cannot come
into contact with a moveable part of the housing unit and does not
pass through any space susceptible of becoming congested.
• Grease cranes produced at the factory to meet the requirement of
all life hob.
Built-in Gas Hob | Encimera Vitrocerámica Gas | Placa Vitro Gás
EN
21