Hilti SPN 6­-A22 Manual De Instrucciones página 11

Careful handling and use of electric tools
▶ Make sure that there is no swarf or dirt on the product. When working, make sure that no swarf makes
its way into the area of the on/off switch. The swarf could block the on/off switch, rendering it impossible
to switch the product off.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held cordless nibbler. It is designed for cutting sheet-like workpieces out of
punchable materials such as steel, aluminum, non-ferrous metal and plastic, for nibbling straight or curved
outside edges and cut-outs and for nibbling along marked lines of cut. The nibbling process produces
distortion-free cut edges. Other applications are possible as well, depending on the accessory tool used.
SPN-CN: This accessory tool is also designed for cutting pipes, nibbling corrugated metal and nibbling with
a template. The hollow round punch enables the nibbler to be rotated about its own axis so that nibbling can
proceed in any direction.
Optional: SPN-RN and SPN-RL: These accessory tools are also designed for cutting sheet metal profiles
such as trapezoidal sheet metal, corrugated sheet metal, box-section sheet metal and angled moldings.
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Items supplied
Nibbler, Torx wrench, operating instructions
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your local
Hilti Store or online at: www.hilti.group
Before being dispatched, the product was tested to ensure that it is in full working order. There
workpiece used in testing might have left tiny scratches in the surface of the housing.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
*2253587*
1
2253587
Lockable on/off switch
@
Grip
;
Adjusting knob for speed
=
Battery
%
Battery release button
&
Dust filter
(
Indexing pin
)
Die carrier
+
Securing screws
§
Die
/
Cover ring
:
Punch
∙
Punch guide
$
Casing
£
English 5