Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble or fault
The power tool or battery
gets very hot.
The power tool does not de-
velop full power.
Diminishing cutting perfor-
mance
The motor has no braking
effect.
11
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Notice d'utilisation originale
1
Indications relatives à la documentation
1.1
À propos de cette documentation
•
Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
•
Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
•
Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
1.2
Explication des symboles
1.2.1
Avertissements
Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
12
Français
Possible cause
Electrical fault
A battery with inadequate capacity
was used.
Punch worn
Low battery.
The power tool was overloaded
briefly.
Action to be taken
▶ Switch the power tool off im-
mediately, remove the battery,
keep it under observation, allow
it to cool down and contact Hilti
Service.
▶ Use a battery with adequate
capacity.
▶ Change the punch. → page 10
▶ Change the battery and charge
the empty battery.
▶ Switch the power tool off and
then on again.
2253587
*2253587*
Les termes de
Publicidad
