Blumfeldt Crete Manual página 42

EN
42
Switch on (ignite flame)
1. Make sure the rotary knob is in the "OFF" position.
2. Open the door and slowly open the gas bottle valve by turning it counter-
clockwise.
3. Close the door of the device housing.
4. Press and hold the electronic ignition button until sparks form. Continue
to hold down the ignition button.
5. Press the rotary knob down and turn it to the "HIGH" position. Press and
hold the knob for another 15 seconds to allow the gas to flow.
6. If the flame does not ignite after a few seconds, release the rotary knob
and turn it to the "OFF" position. Wait 5 minutes for the gas to evaporate
and repeat steps 4 and 5.
7. Once the fire has ignited, the flame intensity can be adjusted using the
rotary knob. "LOW" is the lowest position and "HIGH" is the highest
position.
Switch off (extinguish flame)
1. Turn the rotary knob clockwise to the "HIGH" position. Let the rotary knob
come up and then turn the rotary knob further to the "OFF" position.
2. Turn off the gas bottle valve if you are not going to use the device for a
long period of time.