Using The Accessories - Samsung VS20T755 Serie Manual Del Usuario

02 Spinning brush stuck: Something is
stuck in the connected spinning brush
accessory.
❇ ❇ The spinning brush stuck display will not
turn on if the spinning brush motor stops
because it has overheated.
03 No Filter: The washable micro filter is not
assembled correctly
04 Suction power: Displays the current
suction power.
05 Wet brush cleaning mode: Displays when
the wet brush is assembled.
❇ ❇ If either 01, 02, or 03 blinks a few times
and the vacuum cleaner stops operation,
please take action by referring to the
maintenance part of this manual.

Using the accessories

If the spinning brush stops working,
check whether it has overheated or has
something stuck in it. (Please refer to the
troubleshooting part of this manual.)
#10 Disassembling the accessories
• When disassembling the pipe, press the
release button at the rear of the pipe.
• Before disassembling the accessories,
operate in MAX mode for more than
10 seconds to clean the accessories of any
remaining dust or foreign matter.
• When disassembling the brush, press the
release button at the rear of the brush.
#11 Soft Action Brush
Use to clean a wood or linoleum floor.
#12 Turbo Action Brush
Use to clean various floor conditions at home,
it is also suitable to clean carpet.
#13 Mini Motorized Tool
Use to clean bedding.
#14 Combination Tool
Use to remove dust from curtains, furniture,
sofas, etc.
#15 Extension Crevice Tool
Use to remove dust in grooves of window
frames, chinks, corners, etc.
#16 Flexible Tool
Use to clean the places hard to reach such
as the upper or rear parts of furniture, or
ceilings.
NOTE
• The Flexible Tool can be connected to the
Combination Tool and Extension Crevice
Tool.
#17 Wet Brush
Use to clean a wood or linoleum floor with a
wet pad.
❇ ❇ The Wet Brush does not have a dust suction
function.
❇ ❇ When attaching the wet pad, make sure the
pad is in the center of the spin disk.
Using the multi-use wet pad
01 Multi-use wet pad
02 Velcro
03 Spin disk
Attach the multi-use wet pad to the spin disk.
Using the single-use wet pad
04 Attachable pad
05 <Front> Velcro side
06 <Back>
07 Single-use wet pad
1) Attach the attachable pad to the spin disk
and 2) attach a single-use wet pad on top of
each of the attachable pads.
❇ ❇ When using the single-use wet pad, make
sure the direction of the attachable pad is
correct. Velcro side is the front side.
❇ ❇ Discard single-use wet pads after use. Keep
the attachable pads for future use.
❇ ❇ If you use single-use wet pads without the
attachable pads, the cleaning performance
will not be as good.
English 13