1. Turn off and unplug vacuum cleaner from electrical outlet.
2. Pry light lens out at slots as shown on both sides. Rotate lens up and lift off.
CAUTION
Do not plug in or turn on until the vacuum cleaner is completely reassembled.
CAUTION
Do not use a bulb rated over 9W (13V). During extended use, heat from the bulb could
overheat surrounding plastic parts.
3. Remove the light bulb by pulling straight out.
4. To replace the light bulb, carefully insert fully into slot.
5. To replace light lens, place tab at front of lens into slot.
Flat
Screwdriver
Slots
Headlight Lens
-37-