Zanussi ZKN 7124 Manual De Instrucciones página 23

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Spinning starts late or the machine
does not spin:
The machine makes an unusual
noise:
No water is visible in the drum:
The machine does not dry or does
not dry properly:
The laundry is full of different col-
ored fluff:
If you are unable to identify or solve the problem, contact
our service centre. Before telephoning, make a note of the
model, serial number and purchase date of your machine:
the Service Centre will require this information.
www.zanussi.com
All manuals and user guides at all-guides.com
The electronic unbalance detection device has cut in because the laundry is
not evenly distributed in the drum. The laundry is redistributed by reverse rota-
tion of the drum. This may happen several times before the unbalance disap-
pears and normal spinning can resume. If, after 10 minutes, the laundry is still
not evenly distributed in the drum, the machine will not spin. In this case, re-
distribute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spinning
programme.
The machine is fitted with a type of motor which makes an unusual noise com-
pared with other traditional motors. This new motor ensures a softer start and
more even distribution of the laundry in the drum when spinning, as well as
increased stability of the machine.
Machines based on modern technology operate very economically using very
little water without affecting performance.
The drying time or the dryness degree has not been selected.
• Select the drying time or the dryness degree.
The water tap is not turned on.
• Open the water tap.
The drain filter is clogged.
• Clean the drain filter.
The machine is overloaded.
• Reduce the laundry load in the drum.
The selected drying programme, time or dryness degree was not suitable for
the laundry.
• Select the suitable drying programme, time or dryness degree for the laun-
dry.
The fabrics washed in the previous cycle released fluff of a different color .
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the special programme
to clean it (refer to "FLUFF IN THE FABRICS" for more details).
Possible cause/Solution
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
23

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido