Selecting The Operation Mode; Maintenance And Cleaning Instructions; Replacing The Carbon Brushes; Cleaning And Storage - VITO PRO POWER VIBE850 Manual De Instrucciones

Selecting the operation mode

The drill can operate in two different modes drilling and impact
drilling.
The impact drill mode should be used when drilling in concrete,
stone and masonry.
In all other types of work, the drill must be run in drilling mode.
When using the drill for screwdriving and unscrewing, select
drilling mode and ensure the bit is properly secured.
Only select or change the operating mode when the drill is
switched off.
Drilling and percussion/impact drilling:
1. To work on drilling mode, slide the operation mode selector
(4) to the right.
2. To work in percussion/impact drilling mode, slide the
operation mode selector to the left. Never use this mode in
an anti-clockwise direction, otherwise it may damage the
impact drill.

MAINTENANCE AND CLEANING INSTRUCTIONS

The impact drill does not require any additional lubrication or
servicing. However, for a continuous and trouble-free
operation, you must perform regular cleaning and proper
maintenance tasks.
Before performing any checking, maintenance or cleaning task,
switch off the impact drill and unplug the power cord.

Replacing the carbon brushes

The engine won't run if the carbon brushes are worn out. The
carbon brushes must be replaced in good time, otherwise there
will be imperfect contact between the carbon brushes and the
switch, which can cause sparks and damage to the impact drill.
The two carbon brushes should be replaced at the same time by
two brushes with equal characteristics.
1. Unplug the power cord;
2. Loosen the fixing screws and remove the impact drill housing
to avoid that the electrical devices do not move out of place;
3. Disengage the carbon brush holders and remove the worn
brushes;
4. Place some new carbon brushes (pay attention to the
direction in which the brushes are placed);
5. Before fitting the housing, check that all mechanisms and
cables are correctly placed;
6. Place the housing and tighten the fixing screws.

Cleaning and storage

Cleaning
After each use, clean all the components of the impact drill.
Clean the impact drill with a clean, damp cloth blow it out with
compressed air at low pressure.
Careful handling protects the power tool and extends its service
life.
The power tool and its ventilation slots must be kept clean.
Clean the ventilation slots regularly or whenever they become
blocked.
Storage
When not in use, store the impact drill in a dry, clean place, free
of corrosive smoke and out of children's reach.

ENVIRONMENTAL POLICY

The packaging is made up of recyclable materials, which
you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19 /EC on electrical
and electronic equipment waste and its transposition into
national law, power tools must be collected separately and
delivered to the collection sites intended for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
31