Manual Mode - Phottix Mitros+ Manual De Instrucciones

Setting and Adjust Ratio Modes
TTL Mode
1. After entering OP Tx (Master) mode (above) press the
the OP Tx (Master) parameters.
2. Press the button to select the TTL mode.
3. Pressing the button, the EV compensation option will be highlighted
and flash on the LCD.
4. Press the and
value (from +3 to -3 in 1/3rd stops).
5. Press the button to enter parameter setting screen.
6. Press the and
Mode.
7. Press the and
Ratio Modes: M: A and M: A: B).
8. Press the button to confirm and exit.
TTL Mode
1. After entering OP Tx (Master) mode (above) press the
the OP Tx (Master) parameters.
2. Press the button to highlight the ratio area.
3. Select the Ratio mode. Pressing the
between M:A and M:A:B modes.
4. When M:A or M:A:B is highlighted pressing the
the ratio adjustment selection below the ratio.
5. Press the and
1, 2, 3, 4; Ratio Modes: M: A and M: A :B; Ratio: each group can be set between-
"-" (OFF), 1, 2, 4, 8, 16).
6. Press the button to confirm and exit.
Please note:
The Mitros+ Flash in TTL can show EV compensation setting options and
make EV compensation adjustment only with SLT-A99V/ SLT-A99 and SLT-A58
cameras (as new cameras are released this list may increase). The Mitros+ can-
not show EV compensation setting options or make EV compensation adjust-
ments when used with other cameras. The EV settings are invalid.

Manual Mode

1. After entering OP Tx (Master) mode (above) press the
change the flash into Manual (M) Mode.
2. Press the button to edit the OP Tx (Master) parameters and to
highlight the ratio area.
13
button to edit
buttons will adjust the EV compensation
buttons to cycle between Channel and Ratio
to adjust the parameters. (Channel: 1, 2, 3, 4;
button to edit
and buttons will cycle
button will highlight
buttons to adjust the parameters. (Channel:
En
3. Pressing the
M: A:B modes.
4. Press the
5. Press the
6. Pressing the
(1/1 to 1/128 in 1/3rd stops).
7. Press the
button to
INSTRUCTION MANUAL
and buttons will cycle between M:A and
button to confirm and exit the screen.
button to adjust power levels.
or buttons will change the Flash Power Level
button to exit power level adjustment mode.