Ec Declaration Of Conformity; Fcc Compliance Information - Phottix Mitros+ Manual De Instrucciones

EC Declaration of Conformity

We Phottix (HK) Ltd.
Of 10/F Block A, Yip Fat Factory Building, Phase 1, 77 Hoi Yuen Rd, Kwun Tong,
Kln, Hongkong
The European Authorized Representative
Phottix Europe Sp. z o.o.
Piotrkowska 66
90-105 Lodz, Poland
KRS 0000327336
declare herewith that the product designated below:
Product name: Phottix Mitros+ TTL Transceiver Flash
Model No.: Mitros+
complies with the relevant fundamental requirements as per R&TTE Directive
1999/5/EC, insofar as the product is used correctly, and the following standards
or other normative documents
ETSI EN 300 440-1 V1.6.1 (2010-08)
ETSI EN 300 440-2 V1.4.1 (2010-08)
ETSI EN301 489-1 V1.9.2/2011-09
ETSI EN301 489-3 V1.4.1/2002-08
EN 62479: 2010-09
Signed by:
Paul Czernik
CEO/Prezes Zarządu
Phottix Europe Sp. z o.o.
Lodz, September 2013
17
INSTRUCTION MANUAL
En

FCC Compliance Information

Company:
Phottix (HK) Ltd.
Phottix Mitros+ TTL Transceiver Flash
Name:
Model Number:
Mitros+
FCC ID: P9M-MITROSPS
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a resi-
dential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
www.phottix.com