Maintenance; Checking And Adjusting - Wacker Neuson VAL 300 Manual De Operación

All manuals and user guides at all-guides.com

Maintenance

3. Maintenance
3.1

Checking and Adjusting

THIS SECTION IS VERY IMPORTANT: Here are a few simple
instructions to check your laser for calibration. The laser is a precision
instrument and it is important that you keep it calibrated and in proper
condition. The accuracy of your work is completely your responsibility
and you should check your instrument before beginning each job, and
especially after the instrument has taken a sharp jolt or been dropped,
or when temperature changes greater than 50 degrees F (28 degrees
C) have occurred.
See graphic: wc_gr004580
The laser has two horizontal axes: X and Y, as indicated on the top of
the laser.
Each end of each axis must be checked for calibration. If needed, the
axis can be calibrated, carefully following the instructions. You can
also take the laser to a Wacker Neuson service center for calibration.
wc_tx000805gb.fm
EN-19
VAL 300