Using The Jig For Repair Applications; Using The Jig For Mitered Corners - Kreg KPHJ920 Manual Del Propietário

Using the Jig for Repair Applications

a. Remove the material thickness stop (B).
b. Position the jig on the workpiece.
c. Clamp and drill the pocket-holes.
B

Using the Jig for Mitered Corners

a. Remove the material thickness stop to get a screw close to the miter toe.
b. Position the drill guide on the workpiece, angled away from the miter toe.
c. Clamp the drill guide in place and drill the pocket hole.
2x4
Note For distances of 6" (152 mm) or more between pocket holes, drill a pocket hole
midway between the two. In general, space pocket holes about 3" (76 mm) center-to-center
along a joint. You can drill pocket holes in both parts or drill them all in one part.
Note
bit does not change.
2x6
The position of the stop collar on the drill
2x8
1½"
(38 mm)
9