Connection Of Piping(Indoor); For Left Rear Piping - AERMEC MGH Instrucciones De Instalación

Connection of piping --
Indoor
Preparing the indoor unit's piping and
drain hose for installation through the
wall.
Remove the plastic tubing retainer(see
illustration below) and pull the tubing and
drain hose away from chassis.
Replace the plastic tubing holder in the
original position.(Optional).
Drain hose
CAUTION
When install, make sure that
the remaining parts must be
removed clearly so as not to
damage the piping and drain
hose, especially power cord
and connecting cable.

For left rear piping

1. Route the indoor tubing and the drain
hose in the direction of rear left.
Drain hose
2. Insert the connecting cable into the
indoor unit from the outdoor unit
through the piping hole.
Do not connect the cable to the indoor
unit.
Make a small loop with the cable for
easy connection later.
3. Tape the tubing, drain hose and the
connecting cable. Be sure that the drain
hose is located at the lowest side of the
bundle. Locating at the upper side can
cause drain pan to overflow inside the unit.
Loop
Connecting
cable
Drain hose
NOTE: If the drain hose is routed inside the
room, insulate the hose with an insulation
material* so that dripping from
"sweating"(condensation) will not damage
furniture or floors.
*Foamed polyethylene or equivalent is
recommended.
4. Indoor unit installation
Hook the indoor unit onto the upper portion
of the installation plate.(Engage the two
hooks of the rear top of the indoor unit with
the upper edge of the installation plate.)
Ensure that the hooks are properly seated
on the installation plate by moving it left and
right.
Press the lower left and right sides of the unit
against the installation plate until the hooks
engage into their slots(clicking sound).
5. Connecting the pipings to the indoor unit
and drain hose to drain pipe.
Align the center of the pipings and
sufficiently tighten the flare nut by hand.
Indoor unit tubing
7
Gas side
piping
Liquid side
piping
Connecting
cable
Drain hose
Flare nut Pipings