Technical Characteristics; Important Notice - Vimar ELVOX ECP2 Manual Para El Conexionado Y El Uso

Electronic single-phase programmer for the automation of electrical geared motors for roll-up shutters with built-in radio receivers.

TECHNICAL CHARACTERISTICS

-Power feed: 230 Vac 50-60Hz 4.5W max.
-Outlet blinking light: 230 Vac 40W max.
-Motor outlet: 230 Vac 1350W max.
-Aux. power-feed outlet: 24 Vac 3W max.
-Button and safety device inputs: 24 Vdc.
-Operating temperature: -20 ÷85 °C.
-Radio receiver: 433.92 MHz
-Radio transmitters used: fixed code (dip-switch).
-Storable radio codes: 120 .
-Box dimensions: 167 x 116 x 73.
-Container:ABS V-0 ( IP55 ).

IMPORTANT NOTICE

The manufacturer reserves the right to introduce modifications without prior notice; the manufacturer does not bear any responsibility for damage or injury
caused by improper use or wrong installation. Before installing and programming the control unit, carefully read this instruction manual.
- This instruction manual shall only be used by technical staff specialized in automation installation.
- No information contained herein may be of interest to final users.
- All maintenance or programming operation shall only be performed by skilled technical staff.
AUTOMATION SHALL BE PERFORMED INACCORDANCEWITH CURRENT EUROPEAN STANDARDS:
EN 60204-1 (Safety of Machinery, electrical equipments of machines, part 1: general rules).
EN 12445 (Safety in use of power operated doors - testing methods).
EN 12453 (Safety in use of power operated doors - requirements).
- The installer shall provide for the installation of a device (for ex. magnetothermic switch) garanting the omnipolar sectioning of the power supply mains.
- Standards require a minimum contact separation of 3 mm at each pole (EN60335-1).
- Use fittings complying with protection rating IP44 or higher to connect flexible and not flexible pipes or fairleads.
- Installation reqires deep knowledge of electricity and mechanics and shall only be carried out by skilled professionals who shall issue a type.
A Declaration of Conformity for the complete installation (EC 89/392 Machinery Directive,Appendix IIA).
- Following standards for motorised doors shall apply: EN 12453, EN 12445, EN 12978 and local regulations, if any
- The electrical system for the automation shall be done to perfection and shall meet current standards.
- The pushing force adjustment of the door shall be measured with a special instrument and adjusted in accordance with the maximum allowed values of EN
12453 standard.
- The use of an emergency button to be installed near the automation is recommended (connected to the STOP input on control board).This will stop the gate
immediately in case of danger.
- Connect the motor earth wire to the earthing system of the power supply.
NOTES FORTHE INSTALLER
1. If more than one control box is installed, the distance between control boards shall be at least 3 meters to allow the correct working of the radio receiver.
2. The control station has no sectioning device for 230 Vac power supply mains.A special sectioning device shall be provided for during installation.
3. Use fairleads for control station wires.
4. When not in use, the usually closed inputs (NC) shall be connected with cordless plugs.
2
BLINKING LIGHT
COUETESY LIGHT
EN