Publicidad
Idiomas disponibles
Idiomas disponibles
5U106ebk3.book Page 6 Tuesday, April 15, 2003 1:22 PM
8
F i g u r e 1 - 5 .
9
1-6
Installing or Replacing an ERA/O Card
All manuals and user guides at all-guides.com
Reinstall the expansion-card guide:
Holding the expansion-card guide at a 45-degree angle, insert the two tabs at the
a
ends of the expansion-card guide base into the slots on the system board. See
Figure 1-5.
Rotate the expansion-card guide down until the clip snaps securely onto the
b
system board.
R e i n s t a l l i n g t h e E x p a n s i o n - C a r d G u i d e
tabs (2)
slots (2)
Reinstall expansion cards that you removed:
Position the expansion card so that the card-edge connector aligns with the
a
expansion-card connector on the system board. See Figure 1-2.
Insert the card-edge connector firmly into the expansion-card connector until the
b
card is fully seated.
When the card is seated in the connector, close the expansion-card latch.
c
NOTE: SCSI cables connected from an expansion card to the SCSI backplane
board should be routed under the front fan assembly.
Reconnect all expansion-card cables.
d
Publicidad
