BaByliss PRO FX672E Guia De Inicio Rapido página 4

ENGLISH
BABYLISS PRO FORFEX
CLIPPER
POWER DEFINER 2
FX672E
FEATURES:
• Clipper can be used with or
without cord
• 45 mm stainless steel blade
• Direct transmission motor
• Five-setting
adjuster button
• Charging indicator light
• Operating switch
• Illuminated charging stand
• 8 guides for traditional cuts (3 / 6
/ 9.5 / 13 / 16 / 19 / 22 / 25 mm)
• Cleaning brush and lubricating
oil
USE
Charge
Before using your clipper for the
first time, allow it to charge in
its base for 16 hours. Make sure
beforehand that the clipper is
turned off before allowing to
charge.
Plug one end of the the power
cable into the charging base and
the other end into an outlet, the
charging base will light up. Make
sure the charging indicator light is
on. It lets you know that the clipper
is charging properly.
The clipper can be kept in its
charging base without damaging
the battery.
cutting length
To optimize the battery's life,
recharge the clipper regularly and
before the battery is completely
empty.
Light will blink until the unit has
been fully recharged.
Use with cord
The clipper can be used with the
power cord. For this, you need only
plug the cord into the clipper and
then into the outlet. Then push the
operating switch into Position I.
Using the cutting guides
To use the cutting guides, make
sure the clipper is in Position
0. Slide the cutting guide onto
the clipper's cutting head, then
press down until you hear a
click indicating that the sides of
the cutting guide are properly
positioned.
To remove the cutting guide, pull
the sides upwards.
Five-setting
adjuster button
To adjust the cutting length, slide
the adjuster button located on the
front of the clipper into one of the
5 settings.
Maintenance
For best results, the blades should
be cleaned and oiled regularly.
They can be removed to make
it easier to clean. To do so, slide
the height adjuster button into
the lowest (2.8mm) setting, hold
the clipper with the teeth facing
upwards and push towards the
4
cutting length