Headlight Tester Positioning; Mirror Visor Alignment Method; Allineamento Con Visore A Specchio; Laser Visor Alignment Method - KRAFTWERK 505.003.170 Manual De Uso Y Mantenimiento

If area overall slope is higher than 0.1%, it is required to
rework the working area to obtain a flat reference surface.
Vehicle area can be reworked with a proper adjustable
platform and headlight tester area can be completed with
precision rail installation.
Vehicles equipped air suspension, engine must
be on for five minutes before starting the test.
Start headlights check only with engine on.
HEADLIGHT BEAM TESTER LEVELLING:
Position the headlight tester in the center of the related
working area.
Check the position of the level inside the optical box, if it
is not leveled correctly, you will need to level it.
- Loose the snap lever and position the center-
forward to level
- Once the correct tilt is found, tighten the snap lever
- Double-check the correct leveling

7.2 Headlight tester positioning

Position the headlight tester
in front of the car's headlight
at a distance that can vary
between 20-40 cm,
measure the height from the
floor to the center of the
optical box and adjust the
optical box to the
corresponding height using
the graduated scale printed
on the column.
Use the top of the slide skate
as the scale index.

7.2.1 Allineamento con visore a specchio

YES

7.2.2 Laser visor alignment method

Headlight beam tester equipped with laser visor facilitates
operator in aligning the unit in front of the car
Before you begin the alignment identify the working area to
avoid staff exposure to the beam of the laser ray.
The laser device is class 3R according to la norm EN60825-1
Direct observation of the laser ray is not dangerous if eyelid
reflex is preserved breaking the radiation of the cornea in
less than 0.25 seconds, if eyes have no ocular applications
(such as glasses). This case direct exposure is not
recommended.
the alignment operations are complete, turn off the laser.
Look for two symmetrical points at the front of the car,
(e.g.. windscreen or headlights themselves). Turn the optical
box until the two reference points match with the line
projected by the visor.
The laser visor is powered by 3 AA-type stylus batteries. How
to replace: unscrew the 2 screws placed on the plastic lid,
remove the discharged batteries, replace them with new
ones paying attention to the polarity.
NO
23
Look for two
symmetrical points at
the front of the vehicle
(e.g. top of the
windshield or the
headlights themselves).
Rotate the optical box
looking in the mirror the
two marks collimate
with the black line
screen-printed on the
mirror