Troubleshooting Tips - INVENTOR PR1-ION30XL Manual Del Usuario

TROUBLESHOOTING TIPS

Before calling for service, review the chart below.
Problem
,
Make sure the dehumidifier's plug is pushed completely into the
outlet.
Unit does not start
Check the house fuse/circuit breaker box.
Dehumidifier has reached its preset level or bucket is full.
Water bucket is not in the proper position.
Did not allow enough time to remove the moisture.
Make sure there are no curtains, blinds or furniture blocking the
front or back of the dehumidifier.
Dehumidifier does not
The humidity control may not be set low enough.
dry the air as it should
Check that all doors, windows and other openings are securely
closed.
Room temperature is too low, below 5ºC(41ºF).
There is a kerosene heater or something giving off water vapor
in the room.
The air filter is clogged.
The unit makes a loud
The unit is tilted instead of upright as it should be.
noise when operating
The floor surface is not level.
Frost appears on the
This is normal. The dehumidifier has an Auto defrost feature.
coils
Hose to connector or hose connection may be loose.
Water on floor
Intended to use the bucket to collect the water, but the back
drain plug is removed.
These are error codes and protection codes. See the
E122, E142, E163, E554
CONTROL PADS ON THE DEHUMIDIFIER section.
in the display
All manuals and user guides at all-guides.com
What to check
Activate your warranty.....
5
in
simple
steps!
Scan here for the
warranty form
For the electronic
warranty submission
please use the following link
https://www.inventorappliances.com/warranty-card
Connect to the following link
https://www.inventorappliances.com/
warranty-card
Select the product type
(airconditioner or appliance) for
which the warranty will be activated
Choose the warranty that
corresponds to your product
purchase
Fill in the required information
(owner, retailer and appliance)
and press send
You will receive a confirmation
e-mail for the activation of
your warranty