Assembly - Homelite UT13136 Manual Para El Usuario

CHAIN SAW NAMES AND
TERMS
Continued
Device that turns saw on and off. Squeezing
Trigger
trigger turns saw on. Releasing trigger turns saw off.
Process of cutting limb(s) from
Trimming (Pruning)
a living tree.
An upward cut from underside of log or
Undercut
limb. This is done while in normal cutting position
and cutting with top of guide bar.
Main body of chain saw.
Unibody

ASSEMBLY

Note: Some models are pre-assembled. Assembly is
not needed on these models.
See Saw Chain Tension Adjustment, pages 8 and 9.
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp chain saw in
vise during assembly.
1. Lay chain out flat.
2. Loosen and remove guide bar nut and sprocket
cover.
3. Rotate guide bar retainer so that it is positioned
parallel to guide bar slot (see Figure 4).
4. Install guide bar onto saw body. Assemble center
slot of guide bar onto guide bar bolt and guide bar
retainer. Note: Make sure the head of the guide
bar retainer slides through the guide bar slot as
shown in Figure 4.
Drive
Sprocket
Figure 4 - Unlocking Guide Bar Retainer
120692
All manuals and user guides at all-guides.com
Guide Bar
Guide Bar Retainer
Positioned Parallel
to Guide Bar Slot
7
5. Rotate guide bar retainer 90 degrees as shown in
Figure 5.
6. Place chain around drive sprocket, along top groove
of guide bar, and around guide bar nose. Note:
Make sure cutting edges of chain are facing in
right direction. Position chain so cutting edges on
top of guide bar face guide bar nose (see Figure
6 and indicator on side cover of saw).
CAUTION: Do not place chain on saw
backwards. If chain is backwards, saw
will vibrate badly and will not cut.
7. Insert tab of sprocket cover into slot on unibody
and rotate sprocket cover onto guide bar bolt
until sprocket cover rests against guide bar (see
Figure 7, page 8).
8. Place guide bar nut, removed in step 2, on guide
bar bolt.
IMPORTANT: Tighten guide bar nut finger tight
only.
Drive
Sprocket
Figure 5 - Locking Guide Bar Retainer
Figure 6 - Saw Chain Direction
Guide Bar
Guide Bar Retainer
Rotated 90 Degrees
to Guide Bar Slot
Towards Guide Bar
Nose
Cutting Edge
Continued
www.desatech.com