Festo LOGO! 8 TP EduTrainer Descripción página 32

12. Make sure that your IP address is within the same range as the Logo!. If it isn't, no connection can be
established between the PC and the Logo!. Look for the IP address in the Logo! main menu to this end. It
appears under "IP Address" in the "Network" menu. Adjust your IP address to the Logo!:
- Open the control panel at your PC.
- Then go to the "Network and sharing center".
- Click "Local Area Connection".
 The "Local Area Connection Status" dialog appears.
- Click "Properties".
- Then double click "Internet Protocol Version 4 (TCP/IPv4)".
- Change from "Obtain an IP address automatically" to "Use the following IP address:".
 Then enter a similar IP address which lies within the same range as the Logo!.
Example:
13. Transmit the control program to the LOGO!. Select the PC  LOGO! command under Transmit in the
Extras menu to this end. Transmission can of course also be started by clicking the corresponding icon
in the toolbar. The "Interface" window appears, in which you can search for contactable controllers and
execute testing to determine whether or not you can establish a connection with a LOGO!. Click button 1
(see below) in order to look for available controllers within the network. Select the desired LOGO! from
the field (see 2 below) and click the "Test" button (3) to conduct testing. Connection can now be
established by clicking OK (4).
Establishing connection with a Logo!
If you didn't set the Logo! to the STOP mode beforehand, a message appears at the monitor asking
whether you would like to set do so now. This is necessary in order to transfer the program to the Logo!.
The Logo! can be subsequently set to the RUN mode.
32
LOGO! IP address:
PC's IP address:
192.168.0.2
192.168.0.3
3
1
2
4
© Festo Didactic 8049519