SJE Rhombus Installer Friendly Serie Manual De Instalación Y Operación página 3

C-Level™ Sensor Positioning
Keep vent above water level.
Stow excess tube using a
cable tie.
Caution: Do not overtighten
and pinch vent tube.
Do not use the hose clamp
to attach the vent tube.
Doing so will cause sensor
to fail.
4 inch (10.2 cm)
minimum set level
0 inch (0 cm) liquid
level measured from
approximately this point
1 inch (2.5 cm)
minimum from bottom
of tank or from sludge
Timed Dose Application
timer
override
high water
alarm
timer
enable
redundant
o
0
C-Level™ Sensor and Float Switch Installation
hose
clamp
cable
tie
hose
clamp
high water
alarm oat
(recommended)
redundant o
oat
(recommended)
Float Switch Positioning
CAUTION!
If the C-Level ™ sensor or oat
switches are not mounted and
connected correctly, the pumps
and alarm will not operate
properly.
3.5"
(9 cm)
Demand Dose Application
ag (duplex
l
only)
high water
alarm
start
stop
0
high water
alarm oat
(recommended)
redundant
o oat
(recommended)
E3