9- User manual:
the rolling shutter can be controlled with the wired push-buttons or the remote control with the dedicated buttons for
opening stopping or closing stopping.
The wired push-buttons can be configured for manned operation (the rolling shutter will move only while holding down the button, stopping when
released) or automatic operation (by pressing and releasing the button the rolling shutter will move until completely open or closed, pressing the
same button again during the movement of the rolling shutter will cause it to stop).
10 - Troubleshooting
Problem
The automation system does not
work
You cannot save the remote con-
trols
The rolling shutter starts and then
stops immediately
The awning fails to move after the
light sensor has tripped
26
All manuals and user guides at all-guides.com
Cause
No mains supply
Blown fuses
DL1 flashes rapidly
Batteries of the remote control di-
scharged
Remote control not compatible with
the first one saved
Reached memory saturation
Trimmer TR1 not regulated
Automatic operation blocked by si-
multaneously pressing the buttons
connected to the open and close
wired input
Light sensor blacked out
Incorrect DIP switch setting
OPEN
CLOSE - STOP - CLOSE
CLOSE
Solution
Check the power line switch
Replace the fuses with others of the same value
Check the connection of the safety device on input IN3, if the control unit works with the
rolling shutter setting (N.C. contact )
Replace the batteries
The first saved remote control configures the control unit to save only rolling-code re-
mote controls or only hard coded remote controls.
Delete at least one remote control or add an external receiver (maximum capacity 100
remote controls with 2 buttons)
Increase the time with the trimmer TR1
Press the open or close button to return to automatic operation
Clean the lens of the light sensor
Change the setting of the DIP switches, turn the power off and back on again
OPEN - STOP - OPEN
OPEN
CLOSE
EN