Installation - THERMEx ALSACE UDTRAEK Instrucciones De Montaje

M 520192161219092019

INSTALLATION

There are various models of Alsace Pull-out available. It is designed for installing in a cabinet or on a wall by using the enclosed brackets. Alsace
Pull-out can be supplied with both an internal and external motor and can be used for extraction to the outside or recirculation.
Follow the instructions that match the model and type of installation you have chosen.
INSTALLATION IN A cABINET
The hood can be mounted underneath a cabinet. This is done by following the steps below:
1
x4
Measure out to the motor box underneath
the cabinet.
4
Pre-drill the four holes on the underneath
the cabinet.
7
Install the exhaust outlet on the hood. Take
care to ensure the non-return valve can open
and close freely.
NOTE: It is important to let the air out of the
cabinet if the hood is to be used for recircula-
tion.
2
cut a hole in the hood's motor box on the un-
derneath of the cabinet.
5
x4
Mount the hood in the cabinet using the four
screws supplied.
THERMEX ALSAcE PULL-OUT
3
x4
Mark out the positions of the four screw ho-
les on the underneath of the cabinet.
6
x4
Push the plugs into the four screw holes in
the hood.
37