Wall Installation - THERMEx ALSACE UDTRAEK Instrucciones De Montaje

38 THERMEX ALSAcE PULL-OUT

wALL INSTALLATION

The hood can be installed on the wall on with the brackets supplied. This is done by following the steps below:
1
x4
x2
Mount the brackets onto the motor box
of the hood. This is done by using the four
screws supplied.
4
x2
Pre-drill the holes and install rawlplugs in-
tended for the material into which they are
installed.
7
Install the exhaust outlet on the hood. Take
care to ensure the non-return valve can open
and close freely.
NOTE: This only applies when venting into
open air.
2
Mount the spacer on the hood to close the
gap between the hood and the wall.
NOTE: The spacer can be used in two ways
depending on the distance to the wall.
5
Mount the hood on the wall using the two
screws supplied.
3
x2
Measure out the position of the holes for the
installation of the hood.
6
x4
Push the plugs into the four screw holes in
the hood.
M 520192161219092019