Midwest Ovation Trainer Instrucciones De Armado página 2

4. Lift up on the top wires that rest on top and pull upwards. This
will form the top and the sides of the crate.
5. The bottoms of the two side panels should rest inside the
bottom panel frame. One edge of the top panel should sit
inside the side panel while the other edge should rest outside
of the side panel as illustrated.
6. Lift up with the handle on the side door and rest the door on
top of the crate. This will allow easier access to the front and
end panels.
Reach in and pull the front door panel toward you until it is
fully upright. Secure the front door panel to the top panel by
gently pulling outward on the front panel while pushing down
on the top panel. The hooks on the front door panel will fit over
the end wire on the top panel.
7. Repeat Step 6 with the end panel. Then, while holding the side
door, lift the safety stop to allow the door to completely close.
8. The crate is now fully assembled. To operate the side door,
lift the door upward using the handle. When closing the side
door, the safety stop will prevent the door from closing too
quickly. Use your finger to lift the safety stop upward while
closing; this will allow the door to descend to the bottom of
the crate and into the closed position.
Top Panel
Bottom
Panel
Side
Panels
Safety Stop
2