Fireplace Installation - Dimplex V1525BT Manual Del Propietário

Fireplace Installation

!
NOTE: A 15amp, 120-
volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases. A
dedicated circuit will be required
if, after installation, the circuit
breaker trips or the fuse blows on
a regular basis when the heater is
operating. Additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
WARNINg: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Construction and electrical outlet
wiring must comply with local
building codes and other applica-
ble regulations to reduce the risk
of fire, electric shock and injury to
persons.
Do not attempt to wire your own
new outlets or circuits. To reduce
the risk of fire, electric shock or
injury to persons, always use a
licensed electrician.
WARNINg: The In-Stud
fireplace is wall mountable and
All manuals and user guides at all-guides.com
can be build-in the wall space
16" over-center between 2"x4"
wall studs. Follow the installation
instructions for either wall mount
or built-in mounting; failure to do
so may cause damage or injury.
!
NOTE: Remove glass as-
sembly before installing fire-
place on or into a wall.
1. remove screws securing
glass assembly on the mount-
ing tabs. (Figure 1)
2. Use both handles on the
sides of the glass assembly,
lift and remove the assembly
Figure 1
7