Toto TBW05401 Manual De Operaciones página 55

Phenomenon
Only cold
water comes
out.
Temperature
cannot be
adjusted well.
There is no
discharge even if
the Open/Close
button is pressed
The water flow
is turbulent.
Water leaks from
the connection
between the
shower hose and
the main body
The shower head
turns naturally.
The handle
rattles
z The following phenomena may occur but they are not due to any problem.
Phenomena
There is no high
temperature discharge
Water flow sounds loud
Before asking for repair
Inspection Point
Does a sufficient amount of hot water
come from the hot-water supply?
Does a sufficient amount of hot water
come from the hot-water supply?
Is the filter clogged?
Have the stop valves on the hot and
cold water sides been adjusted?
Has the temperature control handle
been set correctly?
Is the flow adjustment handle open
enough?
Is the nozzle clogged?
Is the filter clogged?
Is the connection between the
shower hose and the main body
loosened?
Is the shower hose kinked?
Have the set screws become loose?
For safety reasons, even if the temperature
adjustment handle is turned fully towards the hot
water side, the structure means that only water up to
about 45°C will be discharged.
It is the sound of water flowing when the flow
adjustment handle has been used to adjust the flow to
a small flow.
Check the water heating
temperature and the operation
of the water heater.
Check the water heating
temperature and the operation
of the water heater.
Clean the filter.
Adjust the flow rate with the stop
valves.
Check the temperature control
handle setting.
Try turning the flow adjustment
handle.
Clean the nozzle.
Clean the filter.
Retighten the shower hose.
Remove the kink in the shower
hose.
Tighten the set screws that
fasten the handle.
Explanation
54
Solution Ref.Page
-
-
Page 31
Page 53
Page 30
Page 29
Page 32
Page 31
-
-
Page 30