Fuji FCH Serie Manual De Instrucciones página 5

EN
* FRH-Baby hammer
1. Loosen and remove Chisel Holder Spring (719).
2. Insert the chisel into Chisel Holder Spring.
3. Screw Chisel Holder Spring onto cylinder (701).
11/2018
Original instructions
* FS-Scaling hammer
1. Remove cap (130), using a monkey wrench or a
spanner (44Hex.).
2. Remove "O" ring (C04), damper (712), Cylinder
Lid (711), and Piston (720) from Cylinder (701).
3. Insert a new Piston in Cylinder and put back
Cylinder Lid, Damper and "O"ring.
4. Screw back Cap.
* CB-Concrete breaker
1. Push protrusion part of Holder Spring (22), and
turn Chisel Holder (18) to the left to remove it.
2. Insert the chisel in Cylinder (16).
3. Screw Chisel Holder on Holder Spring until the
protrusion part of Holder Spring falls into one of the
Chisel Holder notches and to a point where it will not
come out. Be careful not to screw too much. (If it is
screwed to much, no gap will exist between Chisel
and Piston. And this would cause tool breakage).
MANUFACTURER'S LIMITED WARRANTY
Limited Warranty: The "Products" of Fuji Industrial Technique co., Ltd. ("FUJI") are warranted to be free from
defects in material and workmanship for one year from the date of purchase. This Warranty applies only to
Products purchased new from FUJI or its authorized dealers. Of course, this Warranty does not apply to
products which have been abused, misused, modified, or repaired by someone other than FUJI or its
Authorized Service Representatives. If a FUJI Product proves defective in material or workmanship within one
year after purchase, return it to any FUJI Factory Service Center or Authorized Service Center for FUJI tools,
transportation prepaid, enclosing your name and address, adequate proof of date of purchase, and a short
description of the defect. FUJI will, at its option, repair or replace defective Products free of charge. Repairs or
replacements are warranted as described above for the remainder of the original warranty period. FUJI's sole
liability and your exclusive remedy under this Warranty is limited to repair or replacement of the defective
Product. (There Are No Other Warranties Expressed Or Implied And FUJI Shall Not Be Liable For Incidental,
Consequential, Or Special Damages, Or Any Other Damages, Costs Or Expenses Excepting Only The Cost
Or Expense Of Repair Or Replacement As Described Above.)
COPYRIGHT 2011, Fuji Industrial Technique co., Ltd.
All rights reserved. Any unauthorized use or copying of the contents or part thereof is prohibited. This applies
in particular to trademarks, model denominations, part numbers and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of unauthorized parts is not covered by Warranty or Product
Liability.
5
Original instructions
* CA-Concrete breaker
1. Turn Chisel Holder Spring (190) and remove from
cylinder (30).
2. Insert chisel in Cylinder.
3. Screw Chisel Holder Spring on Cylinder.
5412060200 Rev.02