Additional Safety Information; Labels And Icons - Stanley PB2500N NeoBolt Manual De Instrucciones Y Servicio

E N G L I S H
d ) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, fl ush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.

1.1.7 ADDITIONAL SAFETY INFORMATION

WARNING: NEVER modify the tool in any way. Any modifi cation to the tool will void any and all
warranties. Modifi cation may pose a risk of property damage and/or serious risk of injury to the user.
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or
dust mask if installation operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19)
during use. Under some conditions and duration of use, noise from this product may contribute to hearing
loss.
CAUTION: When not in use, place tool on its side on a stable surface where it will not cause a
tripping or falling hazard. Some tools with large battery packs will stand upright on the battery pack but
may be easily knocked over.
• Do not use outside the design intent of placing STANLEY Engineered Fastening NeoBolt® Fasteners.
• Use only parts, fasteners, and accessories recommended by the manufacturer.
• DO NOT abuse the tool by dropping or using it as a hammer.
• Keep tool handles dry, clean, and free from oil and grease.
• Never leave operating tool unattended and disconnect battery when tool is not in use.
• Keep hands away from trigger before connecting to power source and/or battery pack, picking up or
carrying the tool.
• DO NOT operate a tool that is directed towards any person(s).
• DO NOT operate tool with the nose housing removed.
• Keep dirt and foreign matter out of the air vents of the tool as this will cause the tool to malfunction.

1.2 LABELS AND ICONS

Markings on Tool
SERIAL NUMBER POSITION: The Serial Number is located on the Handle (G) on the surface that forms the
joint between the tool and battery. (Fig 1b).
Labels on TOOL, charger and battery pack
In addition to the pictographs used in this manual, the labels on the tool, charger and the battery pack may
show the following pictographs.
Read all documentation
Read all documentation
Wear eye protection
Wear respiratory protection
4
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately
Charge only between 4 °C and 40 °C.