Tabla De Contenido - Stanley PB2500N NeoBolt Manual De Instrucciones Y Servicio

©2018 STANLEY Black & Decker
All rights reserved.
The information provided may not be reproduced and/or made public in any way and through any means (electronically or
mechanically) without prior explicit and written permission from STANLEY Engineered Fastening. The information provided
is based on the data known at the moment of the introduction of this product. STANLEY Engineered Fastening pursues a
policy of continuous product improvement and therefore the products may be subject to change. The information provided
is applicable to the product as delivered by STANLEY Engineered Fastening. Therefore, STANLEY Engineered Fastening cannot
be held liable for any damage resulting from deviations from the original specifi cations of the product.
The information available has been composed with the utmost care. However, STANLEY Engineered Fastening will not accept
any liability with respect to any faults in the information nor for the consequences thereof. STANLEY Engineered Fastening
will not accept any liability for damage resulting from activities carried out by third parties. The working names, trade names,
registered trademarks, etc. used by STANLEY Engineered Fastening should not be considered as being free, pursuant to the
legislation with respect to the protection of trade marks.
CONTENT
1. SAFETY DEFINITIONS ................................................................................................................................ 2
1.1 GENERAL POWER TOOL SAFETY WARNINGS .......................................................................................................................2
1.2 LABELS AND ICONS ........................................................................................................................................................................4
1.3 BATTERIES AND CHARGERS ........................................................................................................................................................5
2. SPECIFICATIONS ........................................................................................................................................ 9
2.1 TECHNICAL SPECIFICATIONS......................................................................................................................................................9
2.2 PLACING SPECIFICATIONS ........................................................................................................................................................ 10
2.3 PACKAGE CONTENTS .................................................................................................................................................................. 10
2.4 MAIN COMPONENTS LIST ......................................................................................................................................................... 10
2.5 OPTIONAL ACCESSORIES .......................................................................................................................................................... 10
3. TOOL USE & SETUP .................................................................................................................................. 11
3.1 INTENDED USE .............................................................................................................................................................................. 11
3.2 NOSE EQUIPMENT ........................................................................................................................................................................ 11
3.3 STROKE SETTING & ADJUSTMENT (FIG 3) .......................................................................................................................... 12
3.4 WORKLIGHT .................................................................................................................................................................................... 13
3.5 CHARGERS ....................................................................................................................................................................................... 13
3.6 BATTERY PACKS ............................................................................................................................................................................. 15
4. OPERATING PROCEDURE ........................................................................................................................ 15
4.1 PROPER HAND POSITION .......................................................................................................................................................... 16
4.2 TOOL OPERATION......................................................................................................................................................................... 16
5. SERVICING THE TOOL .............................................................................................................................. 16
5.1 MAINTENANCE FREQUENCY .................................................................................................................................................. 16
5.2 CLEANING ........................................................................................................................................................................................ 16
5.3 SPARE PARTS AND TOOLS ......................................................................................................................................................... 19
6. PROTECTING THE ENVIRONMENT ......................................................................................................... 20
6.1 THE RBRC® SEAL ............................................................................................................................................................................ 20
7. TROUBLESHOOTING GUIDE ................................................................................................................... 21
8. EC - DECLARATION OF CONFORMITY ................................................................................................... 22
9. BILL OF MATERIAL ................................................................................................................................... 23
10. REVISION HISTORY .................................................................................................................................. 24
E N G L I S H
1