SportDOG X Serie Manual De Funcionamiento página 15

SD-1825X-E
SportDOG Add-A-Dog Collar Receivers must be purchased to train additional dogs in two-, three-, or six-dog
® ®
mode.
TWO-DOG OPERATION
SportDOG Collar Receivers can be set to respond to either the a or b toggle position on the Remote
®
Transmitter.
1. Program the Remote Transmitter to mode 1, 2, 5, 6 or 7 with the toggle in the grey/a position, or any of
modes 1-7 with the toggle in the orange/b position (see TO CHANGE THE MODE on page 12).
2. Next, with the toggle switch in the grey/a position, you can now program the first Collar Receiver.
A. Turn off the Collar Receiver.
B. Press and hold the On/Off Button on the Collar Receiver. The Receiver Indicator Light will come on, then
turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
its normal flashing. If this occurs, start again and repeat from Step A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. If the Receiver Indicator Light does not flash 5 times, start again and repeat from Step A.
3. To program the second Collar Receiver, repeat Steps A through D, but with the toggle switch in the
orange/b position.
THREE-DOG OPERATION
1. Program the Remote Transmitter to mode 3 or 4 with the toggle in the grey/a position (see TO CHANGE
THE MODE on page 12).
2. Next, with the toggle switch in the grey/a position, you can now program the first Collar Receiver.
A. Turn off the Collar Receiver.
B. Press and hold the On/Off Button on the Collar Receiver. The Receiver Indicator Light will come on, then
turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
its normal flashing. If this occurs, start again and repeat from Step A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5
times. If the Receiver Indicator Light does not flash 5 times, start again and repeat from Step A.
3. To program the second Collar Receiver, repeat Steps A through D, using the Lower Button in place of the
Upper Button.
4. To program the third Collar Receiver, repeat Steps A through D, using the Side Button in place of the Upper
Button.
SIX-DOG OPERATION
Repeat Steps 1-4 from "THREE-DOG OPERATION" above for dogs 1-3. Then flip the toggle switch to the
orange/b position and repeat Steps 2-4 for dogs 4-6.
ADD-A-DOG® MODEL
SDR-AXF-E
SDR-AX-E
Original Collar Receiver for: SD-425X-E & SD-825X-E (up to 3 dogs)
Original Collar Receiver for: SD-1225X-E (up to 3 dogs) & SD-1825X-E (up to 6 dogs)
WWW.SPORTDOG.COM 15