Changing Static Stimulation Ranges; General Training Tips - SportDOG X Serie Manual De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 77

CHANGING STATIC STIMULATION RANGES

Your SportDOG® Brand Collar Receiver comes with 2-3 static stimulation ranges depending on the model.
In the Remote Transmitter's default mode there are 21 static stimulation levels within each range, with 1 being
the lowest and 21 being the highest. The default range setting is 2 or medium.
To change the range of static stimulation, follow these steps:
1. Make sure the Collar Receiver is off.
2. Then turn the unit on by pressing and releasing the On/Off button.
3. After the Indicator Light turns off and within 5 seconds, press and hold the On/Off button for 3 seconds.
4. The Collar Receiver will then beep and the Indicator Light will flash orange as indicated by the chart below.
Continue to hold the button until the number of beeps/orange flashes equals the desired stimulation
range shown.
5. Release the button once the desired range is selected; the Collar Receiver will turn off.
6. Turn the unit back on. It will then beep according to the static stimulation range selected in Step 4.
BEEPS
STATIC STIMULATION RANGE
1 beep
Low
2 beeps
Medium
3 beeps
High

GENERAL TRAINING TIPS

BEFORE TRAINING YOUR DOG WITH THIS PRODUCT
You will have the most success using this remote trainer if you always remember to teach a command before
trying to reinforce the command with a remote trainer. Your training will be easier and proceed faster if you
follow the guidelines in this Operating Guide. In addition, always keep the following training tips in mind:
• Eliminate one misbehaviour or teach one obedience command at a time. If you move too fast with the
training, your dog may become confused.
• Keep your training sessions positive, short, and frequent. If you or your dog become frustrated or confused,
it's best to take a break.
• Be consistent. Give your dog a tone, vibration, or static stimulation with each misbehaviour.
• Do not overcorrect your dog. Use as few stimulations as possible to train your dog.
• Restrict your dog from situations in which he has a history of misbehaving unless you can supervise him and
use your remote trainer for applying tone, vibration, or static stimulation.
• If you notice one situation in which your dog misbehaves repeatedly, set up this situation as a training
session. This will dramatically increase your chances of success.
• If your dog has a timid reaction to the tone, vibration, or static stimulation (especially the first couple
of times), do not be alarmed. Redirect his attention to a simple and appropriate behaviour (i.e. a known
command, such as "Sit").
• Never use your remote trainer to correct or eliminate any form of aggressive behaviour. If your dog exhibits
such behaviour, contact a professional trainer. Aggression in dogs is the result of many factors – it may be
a learned behaviour or it may be brought on as a result of fear. Another factor contributing to aggression in
dogs is social dominance. Every dog is different.
At this point, your remote trainer is ready to use. The Transmitter is factory set to mode 5 (mode 5 toggle up
for SD-1825X-E), but you may wish to change the mode to fit your situation. See STEP 5 for an explanation of
mode options.
DOG TEMPERAMENT
Mild
Moderate
Stubborn
WWW.SPORTDOG.COM
MODEL
SD-425X-E, SD-825X-E, SD-1225X-E,
SD-1825X-E
SD-425X-E, SD-825X-E, SD-1225X-E,
SD-1825X-E
SD-1225X-E, SD-1825X-E
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sd-425x-eSd-825x-eSd-1225x-eSd-1825x-e

Tabla de contenido