Bimar HR314 Folleto De Instrucciones página 14

ASSEMBLY
Caution:
- The appliance may only be used if completely and correctly assembled, i.e. complete with
base, columns (n.1 lower, no. 2 intermediate and no. 1 upper) and fixed to the floor.
- before assembling the appliance, make sure it is disconnected from the power point
1. Unscrew no. 6 screws (M6*30) from the base, if previously fixed.
2. The device has to be fixed to the floor using no. 5 screws + washers and with the dowels
(ST4 * 60) supplied. Make sure that in the points where the holes are made there is no
passage of internal pipes (electric, or water, or gas, etc.).
3. Place the counterweight on the floor, using the hexagonal shaped holes "
the points and drill no. 5 holes on the floor. Insert the expansion dowels into the holes,
position the counterweight and tighten the screws with washers.
4. Position the lower column on the base
(with counterweight) in the centre, align
the 6 holes of the column with those of the
base, insert 6 screws (M6
* 30), tighten properly (at the end of the
operation check that the lower column and
the base are firmly coupled) and insert the
ring.
", mark