Advices - Euroclima Radiotactil Manual De Usuario

SETTINGS
Warning: The thermostat's factory settings are appropriate for most applications.
Changes should be carried out by qualified personnel.
The thermostats include settings.
Press for 5 seconds to access the setting mode. will be displayed in .
1
The function is accessed by pressing . By pressing in this function, the
thermostat sends a communication signal to the receiver which causes the led of the
deasignated zone of the control panel to flash.
By pressing again the temperature calibration probe configuration is accessed.
is displayed in alternating with the calibration temperature (default value 0ºC).
2
Generally, the default value should not be changed. The thermostat will add or deduct
the degrees of calibration to/from the degrees measured by the thermostat probe.
By pressing again, is displayed alternating with thermostat's differential (default
20
value 0,5 ºC).
Note: If the key panel is not pressed for 4 seconds, the thermostat returns to normal
operating mode.