Power Supply; Bluetooth Connection; Quick Setup - Montarbo M Serie Manual De Uso

M SERIES
8 ON/OFF
Switch for switching the monitor pair on/off.
9 BLUETOOTH
®
- Indicator lamp: Provides visual (flashing or steady) indication about the
operating status of Bluetooth connection, see also chapter 6.
®
- Button that activates the Bluetooth
®
10 LOUDSPEAKER TERMINAL BOARD 2
Connect the passive loudspeaker through + (red) and - (black) terminals in the terminal
board. NOTE: Use only the supplied two-wire cable. The use of self-made cables with
different lengths and cross-sections could impair the system efficiency.

POWER SUPPLY

4
1
2
1 MAINS INPUT
IEC input socket with integrated mains filter. Each package includes the necessary
power supply cable, specific for your area. With the loudspeaker off, plug the power
supply cable into this socket. Never disconnect the earth plug.
2 FUSE HOUSING
WARNING: If necessary or upon fuse replacement, make sure that the fuse holder
is placed in the direction indicated by the arrows on the cover and according to the
electrical voltage in your area. It is recommended to check this detail before connecting
the unit to the electrical socket.
WARNING: Replace the fuse
only with one of the same type and with the same values. If the fuse continues to fail,
contact an authorised
14
connection (see also chapter 5).
BLUETOOTH CONNECTION
5 ®
- Make sure that the device to be paired to the loudspeaker is switched on and ready for
connection via Bluetooth . With the speaker switched on, press and hold button 9 for a
®
few seconds to activate Bluetooth synchronisation. The relevant blue LED will flash.
®
- Check on your mobile device that the name of the loudspeaker (e.g. M6M) appears
among the available devices.
- Select the loudspeaker model to pair your device. The LED is steady on and signals
correct synchronisation.
(NOTE Upon start-up after the first synchronisation, it is only necessary that the
speaker and the device have the Bluetooth
automatically)
- For proper listening level, adjust the MAIN LEVEL.

QUICK SETUP

6
Place the speakers in correct Connect the passive speaker to
right/left position. With the the active speaker on the back
device off, set the main level using the supplied cable (red
volume to minus infinity terminal to red, black to black).
Connect the power supply unit If a Bluetooth
and switch the devices on enable synchronisation as
described in section (6)
User manual
enabled, and pairing will be performed
®
Perform the necessary
connections of the audio
sources (RCA, TRS balanced,
3.5 mm AUX IN, Bluetooth
source is used, Adjust the audio level and
®
any equalization on the back
depending on
the optimisation required for
listening.
)
®
15