Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
ELECTRIC OUTLET
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It
is recommended that a separate circuit serving only
this appliance be provided.
The drawer is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that
is properly installed and grounded. Should you only
have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
Note: If you have any questions about the grounding
or electrical instructions, consult a qualified
electrician or service person.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Always check electrical
codes for requirements.
Preferred electrical
outlet location*
Figure 4
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded. Consult a qualified electrician
or serviceman if the grounding instructions are not
completely understood, or if doubt exists as to whether
the appliance is properly grounded.
WARNING
Improper use of the
grounding plug can result in
a risk of electric shock.
Do not use an extension
cord. If the power supply
cord is too short, have
a qualified electrician
or serviceman install an
outlet near the appliance.
4
5"
4"
Permanent and
Correct Installation
3-prong plug
Grounding pin
3-prong receptacle
Grounded receptacle box
DRAWER INSTALLATION
Figure 5
1. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
2. Loop (do not tie) a 36" (91 cm) string around the
power supply cord before the drawer is slid into
place. This will keep the cord from falling behind the
drawer.
3. Lift drawer into cabinet cutout using the opening as
a grip. Carefully guide the drawer into the prepared
opening.
4. As you slide the drawer back, pull the string so that
the cord will lie on top of the drawer in a natural loop
and avoid pinching the cord between the drawer and
the wall.
5. When you are sure the cord is out of the way, slide
the drawer ¾ way back into the opening. Remove the
string by pulling on one end of the loop.
6. Slide the drawer all the way until the mounting flange
is flush with the face of the cabinet. See Figure 5.
7. Open the drawer. Using the 4 holes on the mounting
flanges as a template, drill pilot holes the cabinet
using a 1/16" drill bit. See Figure 5.
8. Secure the drawer with the 4 screws supplied. It is
recommended that the screws be hand tightened.
Parts Supplied
Mounting
Flange
4 Screws
31-7000166 Rev. 0
Publicidad
Tabla de contenido
