Technical Data - Rothenberger ROMAX 3000 AC Instrucciones De Uso

If the device is so badly damaged that electric cables or drive parts are exposed, disconnect the
mains plug immediately and contact your service outlet. Unauthorised repair work may result in
the user suffering major injuries or even death.
Only personnel trained in how to use the device may make crimp pipe joints using the ROMAX
3000 AC.
The machine may only be used with a press jaw inserted into it. The press jaw must be in per-
fect technical condition.
Only start the machine if it is in perfect working order.
Servicing and repair work may only be carried out by workshops authorised by ROTHEN-
BERGER.
Use only suitable press jaws and press fitting systems that have been approved by ROTHEN-
BERGER.
After you have inserted the press jaw check that the bolt is securely locked.
In the event of problems during the pressing process, press the EMERGENCY STOP button.
Check that the pipe joint is secure after you have completed the pressing process.
Imperfect pipe joints must be compressed again using a new fitting.
Follow the installation instructions supplied by the fitting and pipe manufacturers.
Assure by pressing leaky press fittings that no humidity respectively lotic water reaches into the
inside of the machine!
After finishing the work, check the installation with appropriate testing equipment and assure that
it is leakproof!
2

Technical Data

Voltage ...................................................................................
Rated power consumption ......................................................
Motor speed................................................................
Maximum piston force .............................................................
Pressing time (according to nominal size) ...............................
Dimensions (L x W x H) ..........................................................
Weight ....................................................................................
Working range (system- dependent) ................................
Application temperature range ................................ -15°C - 60°C / 5°F – 140°F
Protection type ................................................................
Protection class ................................................................
Operating mode ................................................................
Noise pressure level (L
Sound power level (L
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 62841-1.
Vibration total value ................................................................
The Vibration Total Value quoted in these instructions and the quoted noise emission values
were measured according to standardized measurement procedures and can be used to com-
pare one electric power tool with another. They can also be used to make an initial estimate of
the loading.
The quoted vibration and noise emissions can vary during actual use of the electric
power tool dependent on the way in which the electric power tool is used, in particular
what type of workpiece is being processed. Establish additional safety measures to
protect the operator which are based upon an estimate of the vibration loading during the actual
usage conditions (in doing so taking account of parts of the operating cycle, for example times in
which the electric power tool is switched and those in which it is switched on but not running
under load).
12
) .......................................................
pA
) ..........................................................
wA
ENGLISH
230 V a.c., 50/60 Hz
540 W
-1
22 000 min
max. 34 kN
ca. 5 s
465 x 125 x 90 mm
ca. 4,0 kg
ø 12 - 110 mm
IP 20
II /
S3
71 dB (A) ¦ K 3 dB (A)
pA
82 dB (A) ¦ K 3 dB (A)
wA
≤ 2,5 m/s 2 ¦ K= 1,5 m/s 2