Kobalt KCS 1040B-03 Manual De Instrucciones página 20

OPERATING INSTRUCTIONS
• When the log is supported on only one end,
cut 1/3 the diameter from the underside
(underbucking). Then make the finishing cut by
overbucking to meet the first cut (Fig. 10d).
• When the log is supported on both ends, cut 1/3
of that diameter from the top overbuck. Then
make the finished cut by underbucking the lower
2/3 to meet the first cut (Fig. 10e).
• When bucking on a slope, always stand on the
uphill side of the log (Fig. 10f).
• To maintain complete control when cutting
through, release the cutting pressure near the
end of the cut without relaxing the grip on the
chainsaw handles. Don't allow the chain to
contact the ground. After completing the cut, wait
for the saw chain to stop before you move the
chainsaw. Always stop the motor before moving
from tree to tree.
10d
2nd cut overbuck (2/3 diameter)
to meet 1st cut (to avoid
pinching)
1st cut underbuck (1/3 diameter) to
avoid splintering
1st cut overbuck (1/3 diameter)
10e
to avoid splintering
2nd cut underbuck (2/3 diameter) to
meet 1st cut (to avoid pinching)
Log supported on both ends
10f
Stand on the uphill side when
cutting because the log may roll
20
Log supported on one end
Bucking a log