Makita DFR452 Manual De Instrucciones página 9

Installing screw strip
Insert a screw strip through the screw strip guide on
the casing, and then insert it through the screw loading
guide in the feeder box.
5
2
Fig.12
► 1. Screw strip 2. Screw strip guide 3. Casing
4. Screw loading guide 5. Feeder box
NOTICE:
Make sure to set the first screw in the
second row next to the driving position.
2
1
Fig.13
► 1. First screw 2. Driving position
4
3
1
Removing screw strip
To remove the screw strip, pull it upwards out of the feeder box.
Fig.14
The screw strip can be pulled downwards out of the feeder
box while pressing the reverse button on the feeder box.
2
Fig.15
► 1. Reverse button 2. Feeder box
Installing hook
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook may
come off from the tool and result in the personal injury.
1
2
3
Fig.16
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool. This can
be installed on either side of the tool. To install the hook, insert it
into a groove in the tool housing on either side and then secure it
with a screw. To remove, loosen the screw and then take it out.
9 ENGLISH
1
2
1
3